Jump to content

Recommended Posts

All in good condition. Table top is fine as-is but can easily be sanded down and refinished (I’ve done it myself and it takes about 2 hours on a dry day). Table and chair legs have some small chips in places and you could likely find touch up paint if you really wanted it all to feel new.

Large solid oak topped table with charcoal grey legs (originally Cotswold Chester but no longer on website)

H 76 x W 95 x L 220

 

Accompanying ‘Ellwood’ bench H45 x W35 x L195

 

4 accompanying charcoal grey chairs

https://www.cotswoldco.com/dining-room-furniture/dining-chairs/wooden-chairs/spindleback-chair-charcoal/

 

Originally Purchased in 2021 for £1400

Selling due to refurb, £800 all-in

REDUCED TO £600

Viewing Advised

I’m renting a van for Tuesday 24.02 to Thursday 26.02 so can also throw in local delivery then too. Otherwise you’ll need a large car, roof rack or van.

Located in SE22

Mark - 07795591921

 

IMG_2562.jpeg

IMG_2561.jpeg

Edited by markdanielallen
  • Like 1
  • markdanielallen changed the title to REDUCED Cotswold Company Large Dining Table with Bench and Chairs - £600

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Discussions

    • If you want to change a radiator and it is the same size, pretty straight forward.  isolate by turning the two valves, one is straight forward hand twist, the other side you need to take the cap off and get an adjustable spanner and turn till closed.  Both clockwise. Use the same spanner to undo the large nuts that fix the radiator to the pipework, open the bleed valve, get a flatish container to catch the water which is likely to be a grotty black, sheets/plastic underneath to protect floor/floor covering.  Then jiggle off, tipping as quick as you an into your water container. Fingers crossed it will be the same back plate fitting.  If not you will have to take the old one off and fix the new one. Replacement is a reverse, allowing the rad to refill and let the air out. No naked flames involved. If it is a different size I can advise on that too. Lots on line too: https://www.toolstation.com/help-and-advice/how-to-guides/how-to-remove-radiator?gad_source=1&gad_campaignid=19747119835&gclid=CjwKCAiAkvDMBhBMEiwAnUA9BR26YwBA6kOfcR4-JVxfJEjWdhRk6j0imCNcsIfu064wHN54-cs10xoCZ4cQAvD_BwE Although this is for a pressurised (combi) system where you need to get it back to pressure.  Pretty simple.  I don't bother with jointing compound.    
    • Fair enough - I'm absolutely wrong on that one. 👍
    • I'm still completely unclear what happened, apart from that a car apparently crashed into a lamp post opposite the Co-op. I presume the one in Lordship Lane, though the OP doesn't say. Was it speeding? Did it swerve to avoid someone who ran into the road? Did something go wrong with its brakes or steering? Did the driver have a medical emergency or fall asleep or got  distracted by something? Was there something slippery on the road surface? Was the driver hurt? Were any passengers hurt? Were any pedestrians or other road users hurt? Were there any witnesses? 
    • confused by the question?
Home
Events
Sign In

Sign In



Or sign in with one of these services

Search
×
    Search In
×
×
  • Create New...