Jump to content

Recommended Posts

Re. Noisy Buses on Dulwich Grove.

Found this forum following a search on noisy buses. It may be of interest to those concerned that bus noise ( specifically concerning the cooling fan ) is a national problem. We live on what was a quiet residential road in Nottinghamshire.We now have upto 7 buses an hour passing within a few feet of our house, most of which are empty. The worst noise levels ( 95+ decibels) are from Optare Tempo vehicles. The EU directive states that the noise level of a normal single decker vehicle should not exceed 85 decibels. However, as stated elsewhere in the forum when the bus is tested the cooling fan is not taken into consideration. So, consequently many people have to suffer a noise comparable to a jet liner on take off. As we have discovered during the last few years, one must not critiscise buses as they are deemed to be "green". If it was a motor cycle or Heavy Goods Vehicle responsible for this noise level those reponsible would be prosecuted and the vehicle impounded. But in our experience bus companies appear to be a law unto themselves.

Good Luck to the residents of East Dulwich Grove ( PS We have been suffering for 5 years )

Hi jurassic,

Bus services are purchased by Transport for London and they specify what is acceptable to them or not. So we'll be pressing for TfL to use some common sense initially on night buses.


I suspect you have the same set-up with either Nottingham City Council or the County Council procuring bus services.

Good luck.

Hi James

Thanks for your response. Initially the bus company involved was a private company and we understand with no subsidy. The route past our house is only used as there is nowhere else for the buses to turn round. Following 4-5 years of complaints we now have another bus company ( possibly subsidised by Notts C.C.) using our road. We and many other residents have communicated with Notts C.C. ,Rushcliffe B.C. and the Local Town Council. We have communicated with our local MP. Mr Kenneth Clarke ( what a waste of time and paper that was). The bus company have recently communicated direct with us, to show us their concern. A complete turnaround compared to previous arrogant and rude communication from them. Research has highlighted that bus noise is a national problem, caused by the loophole is noise regulations allowing bus manufacturers to effectively disconnect the cooling fan during testing.N.B. Am error in my last entry. The noise level should not exceed 80 decibels ( I incorrectly stated 95)

I wish you well but from our experience I suggest you do not expect common sense from the bus industry.

Regards

Jurassic

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Discussions

    • If you want to change a radiator and it is the same size, pretty straight forward.  isolate by turning the two valves, one is straight forward hand twist, the other side you need to take the cap off and get an adjustable spanner and turn till closed.  Both clockwise. Use the same spanner to undo the large nuts that fix the radiator to the pipework, open the bleed valve, get a flatish container to catch the water which is likely to be a grotty black, sheets/plastic underneath to protect floor/floor covering.  Then jiggle off, tipping as quick as you an into your water container. Fingers crossed it will be the same back plate fitting.  If not you will have to take the old one off and fix the new one. Replacement is a reverse, allowing the rad to refill and let the air out. No naked flames involved. If it is a different size I can advise on that too. Lots on line too: https://www.toolstation.com/help-and-advice/how-to-guides/how-to-remove-radiator?gad_source=1&gad_campaignid=19747119835&gclid=CjwKCAiAkvDMBhBMEiwAnUA9BR26YwBA6kOfcR4-JVxfJEjWdhRk6j0imCNcsIfu064wHN54-cs10xoCZ4cQAvD_BwE Although this is for a pressurised (combi) system where you need to get it back to pressure.  Pretty simple.  I don't bother with jointing compound.    
    • Fair enough - I'm absolutely wrong on that one. 👍
    • I'm still completely unclear what happened, apart from that a car apparently crashed into a lamp post opposite the Co-op. I presume the one in Lordship Lane, though the OP doesn't say. Was it speeding? Did it swerve to avoid someone who ran into the road? Did something go wrong with its brakes or steering? Did the driver have a medical emergency or fall asleep or got  distracted by something? Was there something slippery on the road surface? Was the driver hurt? Were any passengers hurt? Were any pedestrians or other road users hurt? Were there any witnesses? 
    • confused by the question?
Home
Events
Sign In

Sign In



Or sign in with one of these services

Search
×
    Search In
×
×
  • Create New...