Tutors & Coaching
Offering or request tuition or coaching - academic, language sport or musical.
⚠️ Only self-employed tutors or coaches based in South London may self-promote their services on this board. No agencies.
677 topics in this forum
-
- 0 replies
- 173 views
-
- 1 reply
- 248 views
-
- 0 replies
- 174 views
-
- 0 replies
- 124 views
-
- 1 reply
- 135 views
-
- 0 replies
- 120 views
-
- 0 replies
- 101 views
-
- 2 replies
- 192 views
-
- 0 replies
- 125 views
-
- 0 replies
- 69 views
-
- 0 replies
- 125 views
-
- 0 replies
- 124 views
-
- 0 replies
- 130 views
-
- 0 replies
- 126 views
-
- 0 replies
- 140 views
-
- 0 replies
- 215 views
-
- 0 replies
- 245 views
-
- 0 replies
- 535 views
-
- 0 replies
- 282 views
-
- 0 replies
- 214 views
-
- 0 replies
- 396 views
-
- 0 replies
- 290 views
-
- 0 replies
- 356 views
-
- 1 reply
- 284 views
-
- 0 replies
- 350 views
-
-
Latest Discussions
-
If you want to change a radiator and it is the same size, pretty straight forward. isolate by turning the two valves, one is straight forward hand twist, the other side you need to take the cap off and get an adjustable spanner and turn till closed. Both clockwise. Use the same spanner to undo the large nuts that fix the radiator to the pipework, open the bleed valve, get a flatish container to catch the water which is likely to be a grotty black, sheets/plastic underneath to protect floor/floor covering. Then jiggle off, tipping as quick as you an into your water container. Fingers crossed it will be the same back plate fitting. If not you will have to take the old one off and fix the new one. Replacement is a reverse, allowing the rad to refill and let the air out. No naked flames involved. If it is a different size I can advise on that too. Lots on line too: https://www.toolstation.com/help-and-advice/how-to-guides/how-to-remove-radiator?gad_source=1&gad_campaignid=19747119835&gclid=CjwKCAiAkvDMBhBMEiwAnUA9BR26YwBA6kOfcR4-JVxfJEjWdhRk6j0imCNcsIfu064wHN54-cs10xoCZ4cQAvD_BwE Although this is for a pressurised (combi) system where you need to get it back to pressure. Pretty simple. I don't bother with jointing compound. -
By Dogkennelhillbilly · Posted
Fair enough - I'm absolutely wrong on that one. 👍 -
I'm still completely unclear what happened, apart from that a car apparently crashed into a lamp post opposite the Co-op. I presume the one in Lordship Lane, though the OP doesn't say. Was it speeding? Did it swerve to avoid someone who ran into the road? Did something go wrong with its brakes or steering? Did the driver have a medical emergency or fall asleep or got distracted by something? Was there something slippery on the road surface? Was the driver hurt? Were any passengers hurt? Were any pedestrians or other road users hurt? Were there any witnesses? -
-