Request a Tradesperson
Need a job done? Require a plumber, builder, gardener...? Ask in here!
Subforums
-
- 879
- posts
-
- 889
- posts
41,806 topics in this forum
-
- 0 replies
- 760 views
-
- 0 replies
- 137 views
-
- 0 replies
- 352 views
-
- 0 replies
- 135 views
-
- 0 replies
- 308 views
-
- 0 replies
- 358 views
-
- 1 reply
- 389 views
-
- 0 replies
- 408 views
-
- 0 replies
- 116 views
-
- 2 replies
- 593 views
-
- 3 replies
- 645 views
-
- 2 replies
- 436 views
-
- 0 replies
- 125 views
-
- 2 replies
- 400 views
-
- 0 replies
- 135 views
-
- 0 replies
- 306 views
-
- 4 replies
- 671 views
-
- 0 replies
- 151 views
-
- 2 replies
- 350 views
-
- 0 replies
- 129 views
-
- 11 replies
- 803 views
-
- 0 replies
- 735 views
-
- 1 reply
- 407 views
-
- 5 replies
- 672 views
-
- 0 replies
- 202 views
-
-
Latest Discussions
-
If you want to change a radiator and it is the same size, pretty straight forward. isolate by turning the two valves, one is straight forward hand twist, the other side you need to take the cap off and get an adjustable spanner and turn till closed. Both clockwise. Use the same spanner to undo the large nuts that fix the radiator to the pipework, open the bleed valve, get a flatish container to catch the water which is likely to be a grotty black, sheets/plastic underneath to protect floor/floor covering. Then jiggle off, tipping as quick as you an into your water container. Fingers crossed it will be the same back plate fitting. If not you will have to take the old one off and fix the new one. Replacement is a reverse, allowing the rad to refill and let the air out. No naked flames involved. If it is a different size I can advise on that too. Lots on line too: https://www.toolstation.com/help-and-advice/how-to-guides/how-to-remove-radiator?gad_source=1&gad_campaignid=19747119835&gclid=CjwKCAiAkvDMBhBMEiwAnUA9BR26YwBA6kOfcR4-JVxfJEjWdhRk6j0imCNcsIfu064wHN54-cs10xoCZ4cQAvD_BwE Although this is for a pressurised (combi) system where you need to get it back to pressure. Pretty simple. I don't bother with jointing compound. -
By Dogkennelhillbilly · Posted
Fair enough - I'm absolutely wrong on that one. 👍 -
I'm still completely unclear what happened, apart from that a car apparently crashed into a lamp post opposite the Co-op. I presume the one in Lordship Lane, though the OP doesn't say. Was it speeding? Did it swerve to avoid someone who ran into the road? Did something go wrong with its brakes or steering? Did the driver have a medical emergency or fall asleep or got distracted by something? Was there something slippery on the road surface? Was the driver hurt? Were any passengers hurt? Were any pedestrians or other road users hurt? Were there any witnesses? -
-