The Family Room Classifieds
Buy, sell, give away items related to family life (e.g. baby equipment, clothes, toys).
68,182 topics in this forum
-
- 0 replies
- 298 views
-
- 1 reply
- 383 views
-
- 0 replies
- 654 views
-
- 1 reply
- 325 views
-
- 2 replies
- 473 views
-
- 0 replies
- 386 views
-
- 0 replies
- 348 views
-
- 0 replies
- 289 views
-
- 0 replies
- 248 views
-
- 0 replies
- 148 views
-
- 1 reply
- 257 views
-
- 1 reply
- 225 views
-
- 0 replies
- 248 views
-
- 0 replies
- 223 views
-
- 0 replies
- 245 views
-
- 1 reply
- 272 views
-
- 1 reply
- 347 views
-
- 0 replies
- 281 views
-
- 1 reply
- 293 views
-
- 1 reply
- 557 views
-
- 0 replies
- 239 views
-
- 1 reply
- 304 views
-
- 2 replies
- 314 views
-
- 0 replies
- 264 views
-
- 1 reply
- 254 views
-
-
Latest Discussions
-
If you want to change a radiator and it is the same size, pretty straight forward. isolate by turning the two valves, one is straight forward hand twist, the other side you need to take the cap off and get an adjustable spanner and turn till closed. Both clockwise. Use the same spanner to undo the large nuts that fix the radiator to the pipework, open the bleed valve, get a flatish container to catch the water which is likely to be a grotty black, sheets/plastic underneath to protect floor/floor covering. Then jiggle off, tipping as quick as you an into your water container. Fingers crossed it will be the same back plate fitting. If not you will have to take the old one off and fix the new one. Replacement is a reverse, allowing the rad to refill and let the air out. No naked flames involved. If it is a different size I can advise on that too. Lots on line too: https://www.toolstation.com/help-and-advice/how-to-guides/how-to-remove-radiator?gad_source=1&gad_campaignid=19747119835&gclid=CjwKCAiAkvDMBhBMEiwAnUA9BR26YwBA6kOfcR4-JVxfJEjWdhRk6j0imCNcsIfu064wHN54-cs10xoCZ4cQAvD_BwE Although this is for a pressurised (combi) system where you need to get it back to pressure. Pretty simple. I don't bother with jointing compound. -
By Dogkennelhillbilly · Posted
Fair enough - I'm absolutely wrong on that one. 👍 -
I'm still completely unclear what happened, apart from that a car apparently crashed into a lamp post opposite the Co-op. I presume the one in Lordship Lane, though the OP doesn't say. Was it speeding? Did it swerve to avoid someone who ran into the road? Did something go wrong with its brakes or steering? Did the driver have a medical emergency or fall asleep or got distracted by something? Was there something slippery on the road surface? Was the driver hurt? Were any passengers hurt? Were any pedestrians or other road users hurt? Were there any witnesses? -
-