Jump to content

Recommended Posts

Courtesy of Mellors, for those of you at the Grove Tavern end of LL, there is a Lewisham textile recycling bin on Sydenham Hill at the Horniman end, about 200 metres before the entrance to Crescent Wood Rd on the left hand side (as you drive from ED). I used it recently and was very grateful not to have to travel to Devon St.
  • 2 months later...
If your are lucky you can park in Barry Road. The bin is in the car park but you access it from Barry Road. Unless you have bags and bags of stuff, you do not need a car. It does get full up quickly so you are advised not to put too much in otherwise it falls out onto the pavement. It is run by a private concern/charity.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Discussions

    • If you want to change a radiator and it is the same size, pretty straight forward.  isolate by turning the two valves, one is straight forward hand twist, the other side you need to take the cap off and get an adjustable spanner and turn till closed.  Both clockwise. Use the same spanner to undo the large nuts that fix the radiator to the pipework, open the bleed valve, get a flatish container to catch the water which is likely to be a grotty black, sheets/plastic underneath to protect floor/floor covering.  Then jiggle off, tipping as quick as you an into your water container. Fingers crossed it will be the same back plate fitting.  If not you will have to take the old one off and fix the new one. Replacement is a reverse, allowing the rad to refill and let the air out. No naked flames involved. If it is a different size I can advise on that too. Lots on line too: https://www.toolstation.com/help-and-advice/how-to-guides/how-to-remove-radiator?gad_source=1&gad_campaignid=19747119835&gclid=CjwKCAiAkvDMBhBMEiwAnUA9BR26YwBA6kOfcR4-JVxfJEjWdhRk6j0imCNcsIfu064wHN54-cs10xoCZ4cQAvD_BwE Although this is for a pressurised (combi) system where you need to get it back to pressure.  Pretty simple.  I don't bother with jointing compound.    
    • Fair enough - I'm absolutely wrong on that one. 👍
    • I'm still completely unclear what happened, apart from that a car apparently crashed into a lamp post opposite the Co-op. I presume the one in Lordship Lane, though the OP doesn't say. Was it speeding? Did it swerve to avoid someone who ran into the road? Did something go wrong with its brakes or steering? Did the driver have a medical emergency or fall asleep or got  distracted by something? Was there something slippery on the road surface? Was the driver hurt? Were any passengers hurt? Were any pedestrians or other road users hurt? Were there any witnesses? 
    • confused by the question?
Home
Events
Sign In

Sign In



Or sign in with one of these services

Search
×
    Search In
×
×
  • Create New...