Jump to content

Over sensitive Angle Care motion sensor - Help

lulu

By lulu
in The Family Room Discussion

 Share

Recommended Posts

lulu

lulu

Posted
Posted
Hello, We have Angel Care motion sensor. We have a large cotbed and followed the instructions I.e placed in the centre of the mattress with a piece of plywood. My little one rolls around a lot in her sleep and the monitor keeps going off. It's driving me mad as its constant false alarms. My lO sleeps in her own room so we have to get up to switch it off. Just wondered if anyone had any troubleshooting tips for this? Getting to the point I want to switch it off!!
ludoscotts

ludoscotts

Posted
Posted
We had the tommy tippee one and following the instructions we were told to put the pad in a certain way but it like yours kept going off. We turned ours round. The instructions said to put it in cot with the smallest side to the top of the cot but as our daughter rolled around so much we turned it so it went across width ways instead and never had another false alarm. Does that make sense? Hae you tried this?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing
  • Advertise Here

  • Latest Discussions

    • beansprout
      Yet another burst main... major leak on Lordship Lane nr junction with Barry Rd

      By beansprout · Posted

      In the country, where I have relocated to these things and dealing with council  for all matters are dealt with  in days… freely admit less population than london. Certainly faster in everything.  Not surprised at all about Thames Water - remember years ago calling them about a leak in road - then it took a week for them to come out, despite daily calls from me. Disgusting at that time the lack of concern and wastage of water. Unbelievable that they are not held to account fir anything and that goes for Southwark Council as well.
    • Sue
      Yet another burst main... major leak on Lordship Lane nr junction with Barry Rd

      By Sue · Posted

      But without knowing the cause of the repeated leaks, it's impossible to comment really. Poor repairs? Something wrong further up the system? Lack of maintenance?  When one of the leaks in our road recurred shortly after it had been repaired, a TW guy said to me that the repairers must have jumped too hard on the asphalt (?) laid above the point of the repair when they were getting it to settle (?) and broken the repair. I wasn't sure if he was joking or not 🤣
    • Penguin68
      Yet another burst main... major leak on Lordship Lane nr junction with Barry Rd

      By Penguin68 · Posted

      But in many cases the leaks are happening in the same places again and again, and every inch of pipe outside the Horniman on the South Circular must have been replaced at least 3 times in the last 15 years! Of course the infrastructure in some areas is old, but locally there's been quite a bit of replacement. To little effect it would seem. 
    • Sue
      Noticeboard on Northcross Road

      By Sue · Posted

      Thank you, Pugwash. That's really useful information. Do you know who was responsible for the locks and keys, or which council department? Could you PM me if you don't want to put someone's personal details on here?  It may save me having to speak to Monica. Thanks.

East Dulwich Forum

Established in 2006, we are an online community discussion forum for people who live, work in and visit SE22.

Home
Events
Sign In

Sign In



Or sign in with one of these services

Search
×
    Search In
×
×
  • Create New...