Jump to content

Recommended Posts

Definitely the other hairdressers on Melbourne Grove (across from the ice cream shop). Jenny cuts both my boys hair, is extremely good with children and gives a great cut. She charges ?8 but I always give her ?10 because she is so good.
Have you though about doing it yourself? After paying ?10 like a fool for the lady at Little Clippers to spend 2 minutes lunging at my 7-month-old (he has a lot of hair!) with scissors only to result in a terrible cut, I decided I couldn't do a worse job myself. I've done it twice now and it was easy and he looks great.

We go to the barber/hairdresser beside the post office on Forest Hill Road (near the Co-Op, at the end of Dunstans). It was ?11 for my son but she spent ages cutting and layering (he has loads of very thick, straight hair) and did a great job.


We had a serious mullet-tastic experience at Jazz on Lordship Lane but I think that was probably because of my bad instructions!

Hello,


Rang GMs for an appointment for tomorrow, they said ?10 for my 3yo boy and ?14 for my 5yo girl...!


Can anyone help - what's the name of the other hairdresser on Melbourne Grove, the one opposite the ice cream shop? I'll give them a ring and see if any cheaper.


Thanks

Claire

  • 2 weeks later...
  • 5 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Discussions

    • If you want to change a radiator and it is the same size, pretty straight forward.  isolate by turning the two valves, one is straight forward hand twist, the other side you need to take the cap off and get an adjustable spanner and turn till closed.  Both clockwise. Use the same spanner to undo the large nuts that fix the radiator to the pipework, open the bleed valve, get a flatish container to catch the water which is likely to be a grotty black, sheets/plastic underneath to protect floor/floor covering.  Then jiggle off, tipping as quick as you an into your water container. Fingers crossed it will be the same back plate fitting.  If not you will have to take the old one off and fix the new one. Replacement is a reverse, allowing the rad to refill and let the air out. No naked flames involved. If it is a different size I can advise on that too. Lots on line too: https://www.toolstation.com/help-and-advice/how-to-guides/how-to-remove-radiator?gad_source=1&gad_campaignid=19747119835&gclid=CjwKCAiAkvDMBhBMEiwAnUA9BR26YwBA6kOfcR4-JVxfJEjWdhRk6j0imCNcsIfu064wHN54-cs10xoCZ4cQAvD_BwE Although this is for a pressurised (combi) system where you need to get it back to pressure.  Pretty simple.  I don't bother with jointing compound.    
    • Fair enough - I'm absolutely wrong on that one. 👍
    • I'm still completely unclear what happened, apart from that a car apparently crashed into a lamp post opposite the Co-op. I presume the one in Lordship Lane, though the OP doesn't say. Was it speeding? Did it swerve to avoid someone who ran into the road? Did something go wrong with its brakes or steering? Did the driver have a medical emergency or fall asleep or got  distracted by something? Was there something slippery on the road surface? Was the driver hurt? Were any passengers hurt? Were any pedestrians or other road users hurt? Were there any witnesses? 
    • confused by the question?
Home
Events
Sign In

Sign In



Or sign in with one of these services

Search
×
    Search In
×
×
  • Create New...